Aeroworks QB 150cc YAK 55M

[Aeroworks]

Very Nice Slideshow……..
Especially like the bonus footage you have all the fun!

[cherrybomb48]

Looks like a winner! Any chance to fly it yet?

[Joe Hunt]

[cherrybomb48]

[Joe Hunt]

[Joe Hunt]

Oh, and tailwheel setup!

[Joe Hunt]

Proper pilot install! He's velcro'd in on a tiny strip of velcro for the photoshoot. haha

[Joe Hunt]

baffling... et al

[Joe Hunt]

I decided (for no other reason than I wanted to try something different) to go with two 7008sb RXs. I linked them and set the second one to channels 9-14. I only have nine servos on this plane (gulp :O ) so I put each servo on its own channel and am not going to program any of the servos. :O haha I'm using three power leads into each RX though each RXs own Fromeco Badger switch. I have a SmartFly PE Comp12+ here, so after a few flights I may try that to see if I notice any difference. The BL servos are supposed to draw a lot less current, so we'll see how it goes. Also this will be my first time on Fastest, so that's kinda the motivation... and just to try stuff.

I have both wings and both horizontal stabs RTF with dual rates and expos, too. I soldered up one rudder servo with a PAD... and that's all the further I've gotten. Still have the rudder pull/pull setup, et al

[Joe Hunt]

BTW, the Hitec 9380 servos travel the exact same distance off center out of the box. All 8 of them that I have. I've never experienced that with a servo before.

https://youtu.be/dyXkduQUWlA